Please Read All Instructions Before Install.
Plywood boards should already be at 42” and 51” above the floor measured from bottom of board.
If graphic print is not already installed on structure, install graphic print by pressing rubber edge into frame.
Graphic print install instructions attached at bottom of this document.
Start by pressing in corners then top and bottom lengths then sides.
The graphic will need to be stretched tight to receive the mount.
When mounting the screen on the second side, the graphic will need to be put up and pulled down to fish the power cord.
If present, remove Plastic LG logo piece held on by philips head screw.
Measure and mark holes for wall bracket.
Wall bracket is to be mounted 21” from top of structure and centered left to right.
Hold up wall mount to structure at correct height and level.
Mark hole positions where screws will go.
Cut 1/2” X’s into graphic where screws will pierce graphic.
This is to prevent graphic from catching and twisting on drill and screw.
Drill 1/8” pilot holes to receive screws.
Drill pilot holes only after graphic is cut.
Mount wall bracket to structure using included pan head wood screws.
Use included washer between screw head and bracket.
One more cut needs to be made in the graphic to feed power cable through.
This should be a 2 in "X" with the center at 38.5" down from top of frame and 11.5" from left of frame.
You can now mount TV to structure.
Pulling power cable though the hole you just made.
TV is to be mounted in portrait orientation with inputs at top of screen.
NOTE- The power cable cut needs to be made while graphic is taught. The first side can have power cable pulled through open back of frame.
However, once graphic is installed on second side, it will be impossible to pull power cable though frame. You will need to pull the lower portion of the printed graphic off frame in order to fish power cable up though the second side's hole.